Editing Raspberry PI Magnetometers and Accelerometers

==Slides==
#[http://www.cbsoftwareengineering.com/presentations/RaspberryPiOperatingSystemsTalk.pdf Talk]
#[http://www.cbsoftwareengineering.com/presentations/RaspberryPiOperatingSystemsLab1.pdf Lab 1]
#[http://www.cbsoftwareengineering.com/presentations/RaspberryPiOperatingSystemsLab2.pdf Lab 2]

==Examples==
[https://1drv.ms/f/s!Ar3pO7_GhJY9hOtmaUYC20lCv4T1-g Code]

==<span id="lab1"></span>Lab 1 Supplies==

====Equipment you likely already have====
#Raspberry PI 3 or 3B (2B+ is an alternative)
#8GB to 32GB microSD cards 

====Equipment you may have or could borrow from The Node====
#USB keyboard and mouse for the PI
#Prototype board
#Jumper wires
#HDMI cable and monitor for the PI

====What you will need to purchase====
#BerryIMUv2-10DOF - an Accelerometer, Gyroscope, Magnetometer and Barometric/Altitude Sensor (https://www.amazon.com/BerryIMUv2-10DOF-Accelerometer-Gyroscope-Magnetometer-Barometric/dp/B072MN8ZRC/ref=sr_1_4?keywords=Ozzmaker&qid=1551718025&s=gateway&sr=8-4)
 

==<span id="lab2"></span>Lab 2 Supplies==

====Equipment you likely already have====
#Raspberry PI 3 or 3B (2B+ is an alternative)
#16GB to 32GB microSD cards (or greater)
#Laptop with Windows 10, 8.1 or 7

====Equipment you may have or could borrow from The Node====
#Prototype board
#Jumper wires
#HDMI cable and monitor for the PI

====What you will need to purchase (same as Lab 1)====
#BerryIMUv2-10DOF - an Accelerometer, Gyroscope, Magnetometer and Barometric/Altitude Sensor (https://www.amazon.com/BerryIMUv2-10DOF-Accelerometer-Gyroscope-Magnetometer-Barometric/dp/B072MN8ZRC/ref=sr_1_4?keywords=Ozzmaker&qid=1551718025&s=gateway&sr=8-4)